Side Ejection Punches:

Can be supplied with a knurled base or pinned to stop any turning in the forme. This self clearing punch is designed to allow the wad to pass out through the side of the body. We manufacture upto 12mm.

Any height supplied.

Side Ejection Punches

Top of Page

Slot Punches:

Supplied in widths from 3mm (3/32”) upwards and lengths from 6.5mm (1/4”) upwards. The very narrow sizes can be supplied with a solid body and a dished face to eliminate ejection difficulties.

Any height supplied.

Slot Punches

Cross Punches:

Cross punches we manufacture from 3mm, 4mm, 5mm diameter

Any height supplied.

No Image

Pricker Punches:

Picker punches we manufacture from 3mm, 4mm, 5mm diameter

Any height supplied.

No Image

Top of Page

Inside Bevel:

Supplied with or without springs, this punch will give an extremely accurate hole with a clean vertical cut in the material.

Any height supplied.

Inside Bevel Punches

Top of Page

Centre Bevel:

Supplied with or without springs, this punch, with its centre bevelled cutting edge, gives an extremely long life. Very popular for cutting solid and corrugated board, as well as many other materials. Centre bevel punches can be supplied on a square shank with spring ejection for printers’ type formes.

Any height supplied.

Centre Bevel Punches

Top of Page

Outside Bevel Relieved:

This punch is used mostly for the cutting of gasket materials, etc. It can be supplied without or with a relief hole, which is bored from base of the punch most of the way up to the cutting edge, facilitating clearance of the wads of material through the base of the punch.

Any height supplied.

Outside Bevel Relieved

Top of Page

Washer Punches:

Made to order only. State cut sizes and height when ordering.

Any height supplied.

Washer Punches

Top of Page

Locating Pins:

8mm body, 18mm long, 3.175mm and 4.76mm pin.

Other sizes available.

Locating Pins

Top of Page

Boring Tools:

These piloted cutters are designed to bore a hole exactly the same diameter as that of the punch to be inserted, thus giving an absolutely tight fit. The use of a small diameter pilot drill to give the ‘lead in’ hole for the boring tool also enables the hole to be positioned much more accurately in the forme.

Boring Tools

Top of Page

Steel Stripping Pins:

For automatic stripping units. All with 4mm diameter base 15mm long. Other pins including pointed can be manufactured to order.

Steel Stripping Pins

Top of Page

Steel Stripping Rule:

These rules are supplied in face as foot condition generally on 3 or 4 point body and in range of different heights Also available: Stripping foam.

No Image

Top of Page

Home Page: www.decimalrules.co.uk